Owner manual

Otter II Fish House Seat

Installation and Set-Up Instructions

Sled

(Sold Separately)

Seat Brace (Qty 1)

Parts Identification:

Tools Required:

7/16 Box End Wrench

7/16 Socket and Rachet

Hammer

Installation:

1. Layout all parts.

2. Slide the two pieces of the seat brace (Item

2) together. Hold pin in and slide to desired

position. See Diagram 1.

3. Attach seat brace (Item 2) under the front

edge of the sled (Item 1) as shown in

Diagram 2. Than lower the seat brace and

let it rest on the opposite sled edge.

Diagram 1

Diagram 2

1/4 x 1 Hex Bolt

(Qty 4)

5/16 Washer

(Qty 8)

1/4 Nylon

Hex Lock Nut

(Qty 4)

(Qty 2)

Seat

Backrest

Deluxe

Economy

Seat

PAGE 1
Otter II Fish House Seat Installation and Set-Up Instructions Parts Identification: 1 3 Sled (Sold Separately) Seat Backrest Pin (Qty 2) Economy Seat Brace (Qty 1) 8 7 1/4 x 1 Hex Bolt (Qty 4) 5/16 Washer (Qty 8) Seat 5 6 2 Deluxe 9 1/4 Nylon Hex Lock Nut (Qty 4) Tools Required: 7/16 Box End Wrench 7/16 Socket and Rachet Hammer Diagram 1 Installation: 1. Layout all parts. 2. Slide the two pieces of the seat brace (Item 2) together. Hold pin in and slide to desired position. See Diagram 1.
PAGE 2
If you have the deluxe seat, place the backrest (Item 1) on the seat (Item 2) and line up the holes on the bottom of the backrest and the back of the seat. Insert the pins (Item 3) through the holes. Use a hammer to drive them all the way in. 1 3 2 Deluxe Seat September, 2005 Otter Outdoors Inc. 411 W Congress St. • Maple Lake, MN 55358 Phone 320-963-6480 • www.otteroutdoors.