User Manual

Project Name: INSERT CARD POWER FCC IC V2
Date: 11.2.21
Outside
Part #: 20-56829
Colors, Coatings, and Treatments: Notes:
Designer: Rowell
Rev: A
Confidential property of Otter Products LLC
Reproduction and unauthorized use is prohibited
Otterproducts LLC:
209 South Meldrum Street,
Fort Collins,CO 80521
NOT FOR PRINT -
FOR REFERENCE ONLY
Dielines-
do not print
Folds-
do not print
Process Black
Page: 1 of 2Dieline: 23-83928
FCC compliance statement
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation
Changes or modifications not expressly approved by
the party responsible for compliance could void the
user’s authority to operate the equipment.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be
determined by turning the equipment off and on, the
user is encouraged to try to correct the interference
by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment
and receiver.
-- Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
-- Consult the dealer or an experienced radio/TV
technician for help.
FCC RF Exposure Compliance
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated with
minimum distance 20cm between the radiator and
your body.
ISED compliance statement
This device contains licence-exempt transmitter(s)/re-
ceiver(s) that comply with Innovation, Science and
Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause undesired
operation of the device.
IC RF Exposure Compliance
This equipment complies with RSS-102 radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed and
operated with minimum distance 10cm between the
radiator and your body.
ai163589456448_20-56829_A.pdf 1 11/2/21 5:09 PM