User Manual

ManualsBrandsOttLite ManualsDesk LampsOttLite - Creative Curves LED Desk Lamp - Black

Curve LED Desk Lamp with 4 Brightness Levels

CSA30G59 GX8274N

CONGRATULATIONS!

You’ve purchased the ﬁnest in natural lighting technology with

your new OttLite

product.

PRODUCT REGISTRATION FORM

Please complete the enclosed Product Registration Form and

return it today by mail, or register online by going to:

OttLite.com/warranty

NOTE: THIS UNIT IS FULLY ASSEMBLED

1. Remove lamp from packing placing lamp body base (A) ﬂat

on a steady surface.

2. Connect the AC Adapter input (E) into connector (F) in the

rear-bottom of the lamp.

3. Plug the A/C adapter (H) into a standard household 120V

AC outlet. Note: Only use with the supplied AC adapter

to avoid damage or ﬁre.

4. Turn the lamp ON & OFF using power switch (B) located

in the front lower-side of base (A). Power switch (B) is a

“touch” switch that controls the dimmer function for 4 levels

of brightness.

5. To power LED settings, slightly touch the switch to achieve

the following:

• turn lamp “ON” to 1st brightness setting; touch the

switch “once”;

• for 2nd brightness setting; touch the switch “two-times”;

• for 3rd brightness setting; touch the switch

“three-times”;

• for 4th brightness setting; touch the switch “four-times”;

• to turn lamp “OFF”; touch the switch “ﬁve-times”.

6. To position the shade simply bend the ﬂex-neck (G) as

needed to point the light. Please hold the lamp base (A)

while adjusting the lamp. Take care not to overextend the

lamp to avoid unbalancing it and damage.

SAFETY WARNING: TO REDUCE THE RISK OF

FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS

1. Turn lamp off and WAIT UNTIL LAMP HEAD (C) and

ADAPTER (H) ARE COOL before handling.

2. The LED panel (D) might get hot after several hours of

continuous use, DO NOT place your hands directly on

LED light panel.

3. Never use with an extension cord unless the plug can be

fully inserted into the receptacles in the extension cord.

4. Do not alter the plug.

5. The lamp head included with this unit cannot be replaced by

the consumer.

6. INDOOR USE ONLY.

NOTE: The important safety instructions appearing in this

instruction sheet are not meant to cover all possible conditions

and situations that may occur. It must be understood that

common sense, caution, and care must be used with any

electrical product.

CAUTION! IF THE EXTERNAL FLEXIBLE CABLE OR CORD OF

THIS LUMINAIRE IS DAMAGED, IT SHALL BE EXCLUSIVELY REPLACED BY

THE MANUFACTURER OR ITS SERVICE AGENT OR A SIMILAR QUALIFIED

PERSON IN ORDER TO AVOID A HAZARD. INDOOR USE ONLY.

CAUTION!

THE LIGHT SOURCE OF THIS LUMINAIRE IS NOT

REPLACEABLE; WHEN THE LIGHT SOURCE REACHES ITS END OF LIFE THE

WHOLE LUMINAIRE SHALL BE REPLACED.

FCC PART 15

Note: This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to Part 15 of the FCC

rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications.

However, there is no guarantee that the interference will not occur

in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from

that of the receiver.

• Consult the dealer or an experienced radio/TV technician for help.

Changes or modiﬁcations not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is

subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including

interference that may cause undesired operation

CAUTION! Any change or modiﬁcation to product not

expressly recognized by OttLite Technologies voids OttLite’s

responsibility for proper function of product.

CAN ICES-005 (B)/NMB-005 (B)

AC/DC ADAPTER

Input: AC 100-240V, 50/60 Hz, 0.2A

Output: 12V DC, 0.42A with a Male DC Plug

ENGLISH Curve LED Desk Lamp with 4 Brightness Levels

INS190521 REV080719