User's Manual

6
OPERATION, CONTINUED
Pairing
The Bluetooth
®
Revo NC2
™
speaker microphone may be paired with a
compatible Bluetooth
®
-enabled two-way radio or mobile device. Once
connected, the microphone and speaker of the Bluetooth
®
Revo NC2
™
will be available for use.
When successfully paired, the Bluetooth
®
Revo NC2
™
will remain
paired with the device, even when both the speaker microphone and
the paired device are powered down. There is no need to pair the two
again when powered back up.
Please note that Kenwood (except Viking VP series) radios have a
different pairing mode than other devices and require different pairing
methods on the Bluetooth Revo NC2
™
. The Kenwood-specic steps are
shown in italics below. Viking VP series radios are not subject to these
steps and must be paired in the same manner as all other devices.
1. To enable pairing mode, hold down the multi-function button
and the PTT button at the same time until you hear “Ready to
Pair” and the indicator light ashes red and blue continuously.
For Kenwood radios: Hold down the multi-function button
and the volume-down button at the same time until the Revo
NC2
™
enters pairing mode.
2. Follow the pairing instructions in the user guide for your
mobile phone or tablet or your Bluetooth
®
-enabled two-way
radio.
3. Select “OTTO_PTT_XXXX” in the pairing menu on your
device. The Xs represent the serial number of your specic
Bluetooth
®
Revo NC2
™
speaker microphone. Some devices,
including certain two-way radios do not have a display. Follow
the manufacturer’s guide to engage the pairing mode. If the