Use and Care Manual

Distance at

least 24" /

61 cm

Turn CW

CONNECTING THE LIQUID PROPANE GAS CYLINDER

Place the propane gas cylinder in an upright,

secure position

Position the gas cylinder in such a way that it is upright

and secure and ensure that it does not come into con-

tact with any part of the Otto Lite. Position the gas

cylinder with a distance of 24" / 60 cm from the

Otto Lite so that the radiation heat does not reach

the surface of the gas cylinder or that of the gas

hose.

Also, ensure that the gas hose is not under any

tension.

We recommend setting up the gas cylinder be-

hind and

slightly to the right of Otto Lite.

Connect the propane gas cylinder.

To connect your Otto Lite to the gas cylinder, you

need to screw the regulator coupling onto the tank

valve by turning it in a clockwise direction. Tighten

the coupling hand-tight.

Never use the pressure regulator to tighten the

screw connection!

Connect the end of the gas hose without regulator

to the Otto Lite’s gas inlet connection.

At the end of the gas hose (which is not yet con-

nected), there is a nut with a 5 / 8" UNF thread. You

need to screw this onto the 5 / 8" adapter fitting at

the back of your Otto Lite, turning it clockwise.

Open the gas cylinder valve by turning it

counterclockwise.

COMMISSIONING

You require the following for a safe connection:

• Propane gas cylinder

• A foaming agent (e.g. leak detection spray, soap solution)