Manual

Wiring Diagram
Connection
Box Cover






Main Grill
Safety Grills
Heater
Reset Hole
Recess Box
DIMENSIONS
mm
inches
180, 3rd Avenue / P.O. Box 188, L’ISLET, Qc, G0R 2C0
Tel.: [phone]
Fax: [phone]
www.ouellet.com
INSTRUCTIONS
For installation of the Forced-ow
Floor Drop-in Heater “OFH Series”
ATTENTION
Basic precautions should always be followed to reduce the risk
of re, electric shock, and injury to persons.
-Read all instructions before using this heater.
-This heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces. Keep combustible materials, such as
furniture, pillows, bedding, papers, clothes, and curtains at least
6 in. (153 mm) from the grill of the heater.
-Do not use outdoors.
-Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock or re,
or damage the heater.
-To prevent a possible re, do not block air intakes or exhaust
in any manner.
-A heater has hot and arcing or sparking parts inside. Do not
use it in areas where gasoline, paint, or ammable liquids are
used or stored.
-Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause re, electric
shock, or injury to persons.
WARRANTY
OUELLET CANADA INC. warrants the component parts of its
products against defects in material and workmanship for a one
year period following the date of purchase, under normal use
and service, when proof of purchase of such is provided to
the manufacturer. The obligation of Ouellet Canada inc., under
the terms of this warranty, will be to supply a new unit and
this releases the manufacturer from paying the installation costs
or other secondary charges linked to replacing the unit or the
component part(s).
KEEP THIS INSTRUCTION
PAMPHLET FOR THE USER
INS82-200404-03
LOCATION
Heater is not to be installed in an area where it will be
obstructed by an open door or objects such as curtains, drapes,
towels or furniture.
Do not install air outlet closer than 6 in. (153 mm) from a wall
or a window.
INSTALLATION
1. Heater should be installed recess in the oor.
2. Dissassemble unit by removing the main grill, safety grills
and heater.
3. Provide an opening of 14 3/8 in. X 7 7/16 in. (365 mm X
188 mm) with 8 in. (204 mm) deep.
4. Remove the appropriate knockout from the recess box for
the electrical supply.
5. Secure the recess box with the supplied screws.
Make sure that the aps are over the oor covering.
6. Remove the connection box cover.
7. Pull through about 8 in. (200 mm) of supply wire.
8. Connect the heater leads to the supply leads according to
local and national codes. Refer to the wiring diagram.
9. Install connection box cover.
10. Install the heater in the recess box.
11. Install safety grills.
12. Install main grill with the supplied screws. Ensure fan
blades are free to rotate and the heater assembly is free of any
foreign objects.
13. To test the heater, temporarily set the thermostat at maxi-
mum temperature.
MANUAL HI-LIMIT
How to reset the manual hi-limit:
- Disconnect the power supply of the heater.
- Unscrew and remove the main grill.
- Remove the safety grills.
- Insert a pointed object in the reset hole (see drawing).
- Push rmly until you hear a clic.
- Install the safety grills.
- Install the main grill with the screws.
- Turn the power back on.
Floor Opening
MAINTENANCE
Once a year, remove the dust accumulation inside the heater
using a vacuum cleaner. Cleaning should be done while the
heater is disconnected from the supply circuit.
A qualied technician should perform any other servicing.