Owners Manual Instruction Manual

900-0138-01-00 Rev B 5
Operation
Installation Instructions
Mounting
Figure 2 Wall Mount
Figure 3 DIN Rail Mount
To mount the AXS Port on a DIN rail:
1. Orient the AXS Port
upright so that the DIN
rail clip is next to the rail.
2. Next, place the clip
against the DIN rail.
Hook the upper edge of
the clip over the DIN rail.
3.
Press on the lower edge
to bend it. Slide the clip
over the DIN rail and
snap into place. Release
the clip once the device
is securely in place.
Upper
Edge
DIN
Rail
Lower
Edge
(pressed)
To mount the AXS Port directly on a wall or
flat surface:
1. Insert two screws (appropriate for the
surface) into the mounting holes at the top
and bottom of the device. The holes will
accept up to a #6 screw.
2. Tighten securely.