- Outback Power FLEXware16 Amp Maximum Product Manual

ManualsBrandsOutback Power Systems ManualsNetwork CardFLEXware16 Amp Maximum 30VDC

FLEXware16 Amp Maximum 30VDC/250VAC

Rated Relay and DIN Mount Base with LED

The FLEXware Relay Assembly will activate a two-wire start generator

when wired to the AUX output of either an OutBack FX Inverter/Charger

or an OutBack Charge Controller. The assembly consists of an LED

module and a relay inserted (in one orientation) into a base. The base is

mounted onto the DIN rail of any OutBack AC industrial control panel.

Relay Features:

Rated current - 16 amps AC/DC 8 amps per terminal•

Rated voltage - 30VDC/250VAC•

Coil power draw - 400 mW•

Gold contacts for use in low power situations•

A green LED lights to show the relay energizing when proper •

voltage is applied to the relay coil connectors.

Base accommodates connections for wiring the coil, common relay •

contacts, normally open relay contacts, and normally closed relay

contacts.

LED

RELAY

BASE

FRONT VIEW

SIDE VIEW

Summary of content (4 pages)

PAGE 1
FLEXware16 Amp Maximum 30VDC/250VAC Rated Relay and DIN Mount Base with LED RELAY BASE LED SIDE VIEW FRONT VIEW The FLEXware Relay Assembly will activate a two-wire start generator when wired to the AUX output of either an OutBack FX Inverter/Charger or an OutBack Charge Controller. The assembly consists of an LED module and a relay inserted (in one orientation) into a base. The base is mounted onto the DIN rail of any OutBack AC industrial control panel.
PAGE 2
WIRING INSTRUCTIONS Wire the relay coil from the AUX positive and negative connections of your OutBack product according to the diagram. The coil connections (A1 and A2) are not polarity sensitive and the LED will light in either polarity as long as proper voltage is present. (Required voltage is nominally 12 VDC, with a minimum of 9 volts.) If you are unsure, run the AUX positive wire to the A2 terminal and the AUX negative wire to the A1 terminal, twisting the wires together for a clean look.
PAGE 3
TWO WIRE START GENERATOR HOOK UP GENERATOR FX INVERTER/CHARGER 12V RELAY INVERTER NC COM COIL ON/OFF NO AUX + AUX XCT XCT + There are two screw terminals for each relay contact. Each can handle up to 8 amps. They are tied together internally. COM 11 and COM 21 are the common relay connections. Either can be used for loads under 8 amps. If the load exceeds 8 amps, use both COM 11 and COM 21. r NO 14 and NO 24 are normally open relay connections.
PAGE 4
Corporate Office 19009 62nd Avenue NE Arlington, WA USA (+1) 360-435-6030 www.outbackpower.com European Sales Office C/ Castelló, 17 08830 - Sant Boi de Llobregat BARCELONA, España Phone: +34.93.654.