OutBack Power Owner's Manual

Installation
18 900-0209-01-00 Rev B
Accessory Terminals and Ports
Figure 9 Wiring Compartment
Reset Button
This button is used for several functions, including updating the FLEXmax 100 firmware. See page 53.
HUB Port
This is an RJ-45 port for a CAT5-style cable to connect OutBack system displays or the HUB
communications manager.
Device and LAN Ports
These ports are not currently active. These ports can be activated in the future using firmware updates.
Remote Temperature Sensor Port
An optional battery Remote Temperature Sensor (RTS) is recommended for accurate battery charging.
When the system includes an OutBack MATE3s system display, a HUB Communications Manager,
and multiple devices, only one RTS is needed. The RTS should be connected to the port on the
FLEXmax 100. The system display gives this port the highest priority and will communicate
compensation values to all other devices.
Specialized temperature compensation is available. See page 43 for more information.
Fan Connector
Accessory Terminal
Block
Remote Temperature
Sensor (RTS) Port
MicroSD Card
HUB Port
Reset Button