OutBack Power Charge Control Brackets

FW-CCB2-T Parts List

• One bracket

• Sheet metal screw fasteners

• Two sets of Conduit Nipple Assemblies

FW-CCB2 Parts List

• Two brackets

• Sheet metal screw fasteners

• Two feet

• One Conduit Nipple Assembly

• One Flexible Conduit Assembly

(360) 435-6030 FAX (360) 435-6019 outbackpower.com

FW-Charge Control Bracket Instructions 900-0065-01-00 REV A 1-22-07

FW-CCB2

Flexible Conduit Assembly

FW-CCB2-T

The FLEXware Charge Control Brackets are designed to secure the MX Charge Controller to either

the side or top of a FLEXware 1000 DC enclosure (FW1000-DC) or the FLEXware 500 DC enclosure

(FW500-DC). The brackets secure to each enclosure with sheet metal screw fasteners included in

each hardware kit. A single bracket is used for mounting an MX Charge Controller to the top of each

enclosure and a pair is used for each MX attached to an enclosure side. Tighten each Charge Control

Bracket securely before attaching an MX.

FW1000-DC

FW-CCB, FW-CCB2 and FW-CCB2-T

(Charge Control Brackets)

PAGE 1
FW-CCB, FW-CCB2 and FW-CCB2-T (Charge Control Brackets) The FLEXware Charge Control Brackets are designed to secure the MX Charge Controller to either the side or top of a FLEXware 1000 DC enclosure (FW1000-DC) or the FLEXware 500 DC enclosure (FW500-DC). The brackets secure to each enclosure with sheet metal screw fasteners included in each hardware kit. A single bracket is used for mounting an MX Charge Controller to the top of each enclosure and a pair is used for each MX attached to an enclosure side.
PAGE 2
FW-CCB2-T FW-CCB FW-CCB Parts List • Two brackets • Sheet metal screw fasteners • One Conduit Nipple Assembly FW500-DC Conduit Nipple Assembly MX Charge Controller Bu sh i Lo ng ck Nu t Lo c k Co Nu nd t uit Ni pp le The Conduit Nipple Assembly creates a sealed pass-through from the MX Charge Controller to the FLEXware enclosure.