- Outback Power Maximum Power Point Tracking Charge Controller Model MX60 PV MPPT Installation, Programming and User's Manual

OutBack Power Systems Inc.

Use up to 2 AWG

wire and torque to

30-inch pounds at

terminals.

MATE/HUB

RJ45 jack

If attaching to

plywood, use a 1

5/8” wood screw to

secure the MX60 at

the top slotted hole

and other screws as

needed at interior

bottom holes.

PV+ PV- BAT- BAT+

Four-Position Terminal Block

Chassis/Equipment

Ground Lug

Programmable AUX

Output Jack (supplies

up to 200mA @ 12 VDC

Battery Remote Temp

Sensor (RTS) RJ11 jack

The PV (-) and BAT (-) terminals are connected internally. Only one negative wire may be needed

to connect to the Four-Position Terminal Block if the PV - and BAT- conductors are bonded at the

negative bus bar. See Figures 2 and 3 for sample wiring diagrams.

Figure 1 Field Wiring Connections and Surge Protection