- Outback Power Maximum Power Point Tracking Charge Controller Model MX60 PV MPPT Installation, Programming and User's Manual

OutBack Power Systems Inc.

CHARGER SETUP

This screen allows changes to the MX60’s recharging voltage set points (Current Limit,

Absorb, Float):

• The presently selected numerical value will have an asterisk “ * ” to the left of it.

• Pressing “” selects the value to be changed.

• You may need to re-enter the password to change these settings.

• The default charger output current limit setting is 60 amps and is adjustable up to 70 amps. At

70 amps, a 70A or 80A breaker must be used between the battery and the MX60.

• Change Absorb and Float set points using this screen if the battery manufacturer’s recommen-

dations are di erent than the default values. Otherwise, see page 79 for suggested recharging

voltage set points.

• If a battery remote temperature sensor (RTS) is used, its compensated voltage values can be

viewed in the MISCELLANEOUS (Misc) screen under the Tmp Comp heading.

Please Note: If an RTS is used, set the ABSORB

and FLOAT setting voltage based on a 25°C / 77°F

setting. These are typically the manufacturer’s set

points (always consult the battery manufacturer’s

recommendations). If an RTS is not in use, please

see the Non-Battery Temperature Compensated

System values (page 85) and adjust the ABSORB/

FLOAT values accordingly.

LIMIT ABSORB FLOAT

Amps Volts Volts

*60.0 14.4 13.6

EXIT  - +