- Outback Power Maximum Power Point Tracking Charge Controller Model MX60 PV MPPT Installation, Programming and User's Manual

OutBack Power Systems Inc.

Press the <-VOC> or <+VOC> soft key to select one

of the 13  xed percentage values. Park Mpp applies

to Auto Sweep Mode if the output current is less

than 5 amps; U-Pick always uses the Park Mpp value.

Press the <NEXT> soft key until the MPPT Mode

screen appears.

Note: After adjusting the Park Mpp values, the user must perform a mini-sweep to activate these

new values.

ADVANCED MENU

Park Mpp

77 % VOC

EXIT NEXT –Voc +Voc