1100RE 24 VDC 960 Ah Battery Bank Installation

EnerSys
P.O. Box 14145
Reading, PA 19612-4145
USA
Tel:[phone]
[phone]
EnerSys EMEA
Brussels, Belgium
Tel:[phone]
EnerSys Asia
Guangdong, China
Tel:[phone]
Represented by:
When ordering new batteries, also remember to properly recycle your old lead
batteries. Federal and state regulations require lead-acid batteries be recycled. The
EnerSys
®
nationwide service organization can arrange pickup, transportation to and
recycling at any one of our company affiliated smelters. Call 1-800-972-7372 for
more information.
Please visit www.enersys.com for literature updates.
PRECAUTIONS*
1. Do not bring any heat or flame source near battery.
2. Do not remove pressure relief valves.
3. Do not lift any cells by the terminal posts.
4. Do not tamper with seal nuts on the cell post.
5. Do not remove lead coating from post or connectors and expose any bare copper.
6. Do not allow cell temperature to exceed 105˚F during charging.
7. Do not clean cell with anything other than water/bicarbonate of soda.
8. Do not over torque connections.
9. Do not store VRLA type batteries for over six months without charge,
at normal temperatures.
* These are only a few of the precautions. Please read all accompanying literature thoroughly for specific
safety and installation information
www.enersys.com
© 2008 EnerSys. All rights reserved.
Trademarks and logos are the property of
EnerSys and its affiliates unless otherwise noted.
Publication No: US-VR-OM-002 - March 2008 - Subject to revisions without prior notice. E.&O.E.