Installation Guide

Specifications
22 900-0184-01-00 Rev A
Table 6 Mechanical and Environmental Specifications
Device
ICS Plus
Combiner Box
Rapid Shutdown
Initiator
Circuit Breaker
Control
Relay Trip Breakers
Knockouts 2”, ½”, and ¾” ½” N/A N/A
Dimensions
(H x W x D)
15.5 × 19.5 × 4.5”
(39.4 × 49.5 × 11.4 cm)
14.1 ×7.3 × 3.75”
(30.5 × 17.8 × 12.7cm)
2.0 × 5.25 × 4.4”
(5.1 × 13.3 × 11.2 cm)
Width only:
PNL-75-DC-RT: 1.5” (3.9 cm)
PNL-75D-DC-RT: 2.2” (5.7 cm)
PNL-75Q-DC-RT: 3.8” (9.6 cm)
Weight
~
12 lb (5.4 kg)
~
4 lb (1.8 kg)
0.8 lb (0.36 kg)
PNL-75-DC-RT: 0.7 lb
(0.32 kg)
PNL-75D-DC-RT: 1.15 lb
(0.52 kg)
PNL-75Q-DC-RT: 2.05
(0.93 kg)
Regulatory Specifications
Listings
This product carries a listing report by UL. It is listed to the following standards:

UL 1741 — Inverters, Converters, Controllers and Interconnection System Equipment for Use
With Distributed Energy Resources (2
nd
Edition, 1/28/2010, with revisions through 3/23/2016)
with PV Rapid Shutdown

UL1699 — Standard for Arc-Fault Circuit Interrupters (2
nd
Edition, revised 11/08/2013)

UL1699B — Photovoltaic (PV) DC Arc-Fault Circuit Protection (2
nd
Edition, 1/14/2014)

CSA C22.2 — General Use Power Supplies, No. 107.1-3 Issue: 2001/09/01 Ed:3 (R2011)
with PV Rapid Shutdown
Compliance
This product has been tested to comply with the following standards:

FCC Part 15, Class B
FCC Information to the User
This equipment has been tested and found to comply with the limits for a Class B digital device when
powered by a DC source, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and the receiver.
 Consult the dealer or an experienced radio/TV technician for help.