Outback EnergyCell RE High Capacity Manual

ManualsBrandsOutBack Power ManualsSolar & Wind PowerOutback EnergyCell 1100RE High Capacity AGM Battery Bank 960 Amp-hour 48VDC

PowerSafe DDm

Publication No. US-DDm-IM-003 Page 15

November 2003 www.enersysinc.com

Terminal Bars

Terminal bars are supplied with the battery

system to provide a cell terminal-to-terminal

plate connection.

1. Inspect the system to be assured that all

cells are connected correctly – POSITIVE to

NEGATIVE and according to the

ASSEMBLY DRAWING.

2. Clean the terminal bar contact area with a

stiff-bristle nonmetallic brush/pad until the

lead-plated surface is bright. Be careful not

to remove the lead plating with excessive

brushing.

3. Apply a light coat of heated NO-OX-ID

grease to the terminal bar contact area with

a small paintbrush.

4. Install terminal bar as shown in Figure 26.

5. Torque bolts to 88 in-lbs.

6. Apply a light coat of heated NO-OX-ID

grease to the bolted connections with a

small paintbrush.

INSTALL TERMINAL BARS

FIGURE 26