Outback EnergyCell RE High Capacity Manual

PRECAUTIONS*
1.
Do Not bring any heat or flame source near battery.
2.
Do Not remove pressure relief valves.
3.
Do Not lift any cells by the terminal posts.
4.
Do Not tamper with seal nuts on the cell post.
5.
Do Not remove lead coating from post or connectors and expose any bare copper.
6.
Do Not allow cell temperature to exceed 105
o
F during charging.
7.
Do Not clean cell with anything other than water/bicarbonate of soda.
8.
Do Not over torque connections.
9.
Do Not store PowerSafe DDm type batteries for over six months without charge, at normal
temperatures.
*
These are only a few of the precautions. Please read all accompanying literature thoroughly for specific
safety and installation information.
When ordering new batteries, also remember to properly recycle your old lead
batteries. Federal and state regulations require lead-acid batteries be recycled.
EnerSys’ nationwide service organization can arrange pickup, transportation to and
recycling at any one of our company affiliated smelters. Call 1-800-972-7372 for
more information.
EnerSys Inc. EnerSys EMEA
P.O. Box 14145 Brussels, Belgium
Reading, PA 19612-4145 Tel: [phone]
USA EnerSys Asia
Tel: [phone] Guangdong, China
[phone] Tel: [phone]
www.enersysinc.com
Represented by:
Publication No. US-DDm-IM-003 November 2003
USE EDGE OF MODULE
WHEN POSITIONING BATTERY
Please check our website for literature updates.
DO NOT PUSH ON CENTER
TO POSITION BATTERY