FlexMax FM100 AFCI Installation

Installation

900-0253-01-00 Rev A

Bracket Mount

The second mounting method uses brackets on the top and bottom of the controller. This method mounts

the controller 0.83” (2.1 cm) from the wall. It is useful when mounting the controller next to an OutBack

inverter system, as the conduit openings will align. It is also useful for mounting without making advance

measurements. The FLEXmax 100 controller comes with two identical brackets.

Figure 4 Mounting the Charge Controller (brackets)

To mount using brackets:

1. Using two ¼” hex head lag screws, mount the lower

bracket with the tabs facing upward (1 and 2).

The mounting surface must be strong enough to

support the added weight of the FLEXmax 100.

NOTE: OutBack is not responsible for damage

resulting from inadequate mounting preparation.

2. Lower the FLEXmax 100 onto the lower bracket slots

as shown to the left.

NOTE: The charge controller can rest on the lower

bracket for the rest of the procedure, although it will

need at least one hand to steady it.

3. Insert the upper bracket into the upper slots

4. Using two ¼” hex head lag screws, attach the upper

bracket to the mounting surface as shown to the left

(3 and 4).

Mounting is complete. Proceed to charge controller

wiring or other installation steps.

Slot

Bracket hole spacing: 5.13” (13.0 cm)

Vertical space between upper and lower

bracket holes: About 20" when mounted

NEW