Outback FM60 User Manual

Operation
56 900-0009-01-00 Rev D
Aux Polarity (Advanced Menu)
When the AUX function is ON, 12 volts DC is present at the AUX terminals (Active High). When
the A
UX function is OFF, 0 volts DC are present at the terminals (Active Low).
Aux Polarity allows the user to reverse the availability of this voltage for the Night Light, PV
Trigger, or Diversion Relay functions. When one of these functions has been chosen as the
A
UX function, an arrow in the right hand corner of the screen will reflect the Aux Polarity state.
o
In
Active High
, the user establishes certain conditions for these functions.
o
In the
Active Low,
zero voltage will be available for a function that in
Active High
would normally
have voltage.
Figure 46 Aux Polarity Screen
Reset to Defaults?
Figure 47 Reset to Defaults? Screen
ADVANCED MENU
Reset to Defaults?
EXIT NEXT RESET
Reset to Defaults? To exit the Reset to Defaults menu without resetting the
charge controller:
o Press <EXIT> to return to the main menu.
o Press <EXIT> again to return to the status screen.
This will exit the menu without making any changes to the current settings.
To reset the FLEXmax to factory default settings:
1. Press <RESET>.
2. Press <YES> to confirm the reset. Upon the next power-up, the
FLEXmax will prompt the user to confirm the voltage (see page 18).
3. Press <EXIT> twice to return to the main menu.
4. Press <NEXT> to return to the beginning of the ADVANCED MENU
(see page 49).
This procedure is recommended any time the controller is relocated or the
system is substantially revised. The settings can also be reset to the
defaults by performing a reboot (see page 60).
Are you Sure?
Reset to Defaults
YES NO
ADVANCED MENU
Reset to Defaults?
EXIT NEXT RESET
ADVANCED MENU
Aux Polarity
 Active High
EXIT NEXT MODE
Aux Polarity Screen To select the mode for Aux Polarity:
1. Navigate to the Aux Polarity screen through the
ADVANCED MENU as instructed in Figure 35.
2. Press <MODE> to switch between:
 Active High or  Active Low
To Exit:
o Press <NEXT> to advance the Reset to Defaults? screen.
o Press <EXIT> once to return to the main menu.
o Press <EXIT> twice to return to the status screen.
AUX MODE 
PV Trigger
Output: Off OFF
EXIT NEXT SET MODE
AUX MODE
(
Active Hi
gh
)
AUX MODE

PV Trigger
Output: Off OFF
EXIT NEXT SET MODE
AUX MODE
(
Active Low
)
ADVANCED MENU
Aux Polarity
 Active Low
EXIT NEXT MODE