User Manual

900-0120-01-00 REV A www.outbackpower.com OutBack Power Technologies, Inc.
© 2011 OutBack Power Technologies 19009 62
nd
Ave NE
Arlington, WA 98223 USA
+1.360.435.6030
T M
Shutter
Bushing
Parts
FW-MB3 Bracket
MATE3 System Display and
Controller (sold separately)
8-32 x 1¼”
Machine Screws,
qty 4
8-32 x 3/8”
Machine Screws,
qty 3
1. In the FLEXware assembly (left), remove
the knockout from the chosen opening
for installation of the FW-MB3.
2. Place the FW-MB3 bracket on the side
of the FLEXware assembly. Align the
bracket’s threaded inserts with the two
matching holes above and below the
FLEXware opening.
3. The FW-MB3 has a third threaded insert
(above right). The FLEXware may or may
not have a counterpart hole, depending
on when it was made. If no hole is present, it must be drilled. Using
the FW-MB3 as a template, mark the hole.
4. Remove the FW-MB3 and drill the hole in the FLEXware. This hole
should be 0.18” diameter or larger.
INSTRUCTIONS CONTINUED ON NEX
T
PAGE
Instructions
Third Insert
FLEXware MATE3
Mounting Bracket (FW-MB3)
This document contains instructions for
installing the MATE3 and FW-MB3 to an
OutBack Power FLEXware assembly, either a
FLEXware 1000 or a FLEXware 500 AC
Enclosure (shown).