Installation Guide

Installation
900-0168-01-00 Rev C 21
To install DC cables and hardware:
1. Install all DC cables.
Do not install hardware in a different order from Figure 8. The battery cable lug should be the first
item installed on the stud. It should make solid contact with the mounting surface.
Do not close the main DC disconnect until wiring is complete and the system is prepared for
commissioning.
Figure 8 Required Order of Battery Cable Hardware
CAUTION: Fire Hazard
Never install extra washers or hardware between the mounting surface and the
battery cable lug. The decreased surface area can build up heat.
2. Install the battery terminal covers. These are made of stiff plastic with a snap-on design.
Figure 9 Battery Terminal Covers
Mounting Surface
M8 x 1.25 Stud
Lock Washer
Battery Cable Lug
13 mm Nut
Flat Washer
Insulator
REMOVAL SLOT
If it is necessary to remove the covers, remove
carefully using a flat screwdriver.
Insert the screwdriver into the slot on the
side of each cover and unsnap the cover.