Installation Guide

Installation
22 900-0160-01-01 Rev B
Removing Front Cover
The front cover must be removed in order to access the Radian inverter’s AC terminals and
other connections. These include the
R
EMOTE
and
B
ATT
T
EMP
ports, as well as several sets of
auxiliary terminals.
Twenty-two machine screws are located around the perimeter. Remove these screws with a
#2 Phillips screwdriver. Once they are removed, the cover can be lifted off.
NOTE
: The screws which secure the plastic plates to the cover do not need to be removed.
Figure 11 Removing the Front Cover
NOTE
:
The Radian inverter may ship with only a few screws installed to make it easier to perform
the initial installation. The remaining screws are included in the hardware kit.
Cove
r
Screws
(×22)
Plate
Screws
Plate
Screws