Installation Guide

Installation

900-0160-01-01 Rev B

Terminals and Ports

Figure 12 DC Terminals, Ribbon Cables, and Auxiliary Terminals

WARNING: Shock Hazard and Equipment Damage

It may be necessary to remove the ribbon cables in the course of servicing the Radian. (This

is detailed in the Radian service manual.) The cables must never be removed until all power

has been disconnected for a minimum of one minute. If the cables are removed prematurely,

the Radian’s capacitors will retain a sizable charge, which can cause electrical shock or

severe equipment damage during normal handling. This damage is not covered under the

unit’s warranty.

12V AUX: Delivers 12 Vdc up to

0.7 amps (8.4 watts). The output can

be switched on and off for many

functions. See page 33 for details.

SWITCH INV eceives wires for a

manual on/off switch to control the

inverter. See page 32 for instructions.

NOTE: The ON/OFF INV jumper (J3)

overrides these terminals when installed.

(See above.)

RELAY AUX: Relay contacts with

no voltage (10 amps at 250 Vac or

30 Vdc). The relay can be switched

on and off for many functions. See

page 33 for details.

ON/OFF INV JUMPER (J3): Overrides the

SWITCH INV terminals when installed. When

installed, the inverter is On. The On or Off states

can then only be controlled by the system display.

NOTE: J3 is installed to the ON position during

manufacture, but the Radian inverter is given an

external OFF command at the same time. Its

initial state will be Off.

DC TERMINALS Connects to the battery cables and DC system.

There are two DC positive and two DC negative terminals. Each DC

positive terminal requires separate cables and separate overcurrent

protection. See page 26 for instructions.

RIBBON CABLES Connects the Radian’s power

modules and control board. See Warning below.

The functions for each set of AUX contacts can be programmed

usin

the s

stem dis