Installation Guide

Installation

900-0160-01-01 Rev B

Figure 13 AC Terminals, Ports, and Ground Bus

WARNING: Shock Hazard

After installation, do not remove the covers while the inverter has any source of power. See

the Operator’s Manual for the shutdown procedure before removing the covers.

AC TERMINAL BLOCK

Receives AC input wires

for two input sources (L1,

L2, and N for each).

Also receives AC output

wires (L1, L2, and N).

All neutral wires are

electrically common. See

page 29 for instructions.

REMOTE and BATTERY

TEMP PORTS:

Receive the RJ45 and RJ11

plugs from the MATE3

system display and Remote

Temp Sensor. See page 32

for instructions.

CONTROL WIRING

TERMINAL BLOCK:

Receives control wires for a

variety of functions, including

generator control.

GROUND BUS

Receives ground

wires from multiple

locations. See page

25 for instructions.