Installation Guide

Introduction
900-0160-01-01 Rev B 7
Components and Accessories
IMPORTANT:
 The Radian inverter is compatible with the MATE3 class of system display products. It can be
used with any firmware revision of MATE3s. It can only be used with MATE3 revision
002.017.000 or higher.
 The MATE3s system display must be used when upgrading the inverter to firmware revision
001.006.063 or higher.
 The Radian inverter is not intended for use with the OutBack MATE or MATE2 products. Use
of these products is not supported with the Radian Series.
IMPORTANT:
This product is not stackable with the GS8048 inverter. See page 39.
Table 1 Components and Accessories
Included in Box
Radian Series Inverter/Charger Quick Start Guide
Mounting Bracket
RTS (Remote Temperature Sensor) Hardware Kit
Optional Components for Attachment to Radian Inverter
MATE3-class System Display and Controller FLEXmax Series Charge Controller
GSLC (GS Load Center) series HUB Series Communications Manager
Figure 2 Radian Inverter and Accessories
NOTE: The system display is required if any Radian functions
need adjustment from the factory default settings.
GSLC
Charge Controllers
HUB
Communications
Manager
MATE3s System Display