Outback FX-R Series Operator Manual

ManualsBrandsOutback Power ManualsInverterOutback Power VFXR3648A-01 Inverter

Introduction

900-0167-01-01 Rev A

Inverter Functions



Battery-to-AC inverting which delivers power to run backup loads and other functions

 Provides single-phase output

 Adjustable range of output voltage

 Settable nominal output frequency



AC-to-battery charging (OutBack systems are battery-based)

 Accepts a wide variety of single-phase AC sources



Uses battery energy stored from renewable resources

 Can utilize stored energy from many sources (PV arrays, wind turbines, etc.)

 OutBack FLEXmax charge controllers will optimize PV power production as part of a

Grid/Hybrid system



Rapid transfer between AC source and inverter output with minimal delay time



Uses the MATE3™ class of System Display and Controller products, or the AXS Port™ SunSpec

Modbus Interface (sold separately) for user interface as part of a Grid/Hybrid system

 MATE3s system display is required for grid support functionality (see below)



Supports the OPTICS RE™ online tool

for a cloud-based remote monitoring and control application

 Requires the MATE3 or the AXS Port

 Visit www.outbackpower.com to download



Uses the HUB10.3™ Communications Manager for stacking as part of a Grid/Hybrid system

~ Stackable in series, parallel, series/parallel, and three-phase configurations



Certified by ETL to UL 1741 SA, CSA C22.2, and IEC 62109-1



Field-upgradeable firmware (from www.outbackpower.com); requires MATE3 product or AXS Port

 The MATE3s system display must be used when upgrading the inverter to firmware revision

001.006.063 or higher.



Seven selectable input modes for different applications

 Generator

 Support

 Grid Tied (available in 24-volt and 48-models only)

 UPS

 Backup

 Mini Grid

 GridZero



Single AC input with dual input programming; individualized modes and priorities can be selected

when switching from utility grid to AC generator

 external transfer device required

 system display required for individual programming

NOTE:

This product has a settable AC output range. In this book, many references to the output

refer to the entire range. However, some references are made to 120 Vac or 60 Hz output.

These are intended as examples only.

Outback Power Technologies Intuitive Control System for Renewable Energy