Replacement Part List

Part No 501505 14 F041513A
BC2600 Hydro Series Brush Cutter Owner’s Manual
3. Loosen the four screws (27) holding deck belt cover (29) and remove cover.
4. Follow the steps 3 and 4 in the Transaxle drive belt removal section to remove the Transaxle drive belt.
It may be necessary to pry idler pulley (35) away from its original position to release belt, using a ratchet
with an extension in the square hole on the idler arm should allow the proper leverage to pull it off the
belt.
5. Relieve the tension on the blade belt by pulling the deck idler arm off of the belt. Then walk the belt off of the deck
pulley.
6. Feed the belt back to the engine base then slip the belt off of the clutch.
7. Install the new belt in reverse order making sure the belt is seated properly in the clutch.
Removing tension on the blade belt
8. Reconnect spark plug wire.
LOOKING THROUGH TOP
Belt Routing Diagram
(Top View of Machine)
Blade Drive Belt (with
Transaxle Belt not Shown)
Transaxle Drive Belt
(Seated below drive belt
on clutch)