Replacement Part List

Part No 501505 15 F041513A
BC2600 Hydro Series Brush Cutter Owner’s Manual
TRANSAXLE DRIVE ADJUSTMENT
READ all safety instructions before servicing unit.
DISCONNECT spark plug wire before servicing unit.
1. Disconnect spark plug wire.
2. Adjustments to cable tension are made at the barrel entering the Drive Control Levers.
3. Adjust cable tension by tightening or loosening cable adjustment barrel on rear of engine base (see below).
Moving the cable adjustment barrel OUT increases tension. Moving the barrel IN decreases tension.
Increasing the tension too much will cause the drive to stay engaged whereas not enough will cause it not
to engage when the lever is pulled.
Transaxle Cable Adjustment
4. Reconnect spark plug wire.
DECREASE
INCREASE