Replacement Part List

Part No 501505 7 F041513A

BC2600 Hydro Series Brush Cutter Owner’s Manual

OPERATION

OPERATOR CONTROLS

The operator’s station is at the rear of the machine between the handlebars. The operator should STAND in a position to

allow both handlebars to be grasped firmly and which allows sufficient leverage to steer the machine. Operator’s controls are

shown below.

Operator Control Locations

1 Blade Clutch Lever 5 Start Switch (Electric only)

2 Forward Lever 6 Pull Starter

3 Reverse Lever 7 Choke

4 Throttle

STARTING

CHECK engine oil level before operating machine.

1. Place equipment on a level, firm surface that is free of rocks or other debris.

2. Place throttle in Fast position.

Throttle

3. Pull choke out (Honda engine only).

Choke