Replacement Part List

Part No 501505 8 F041513A
BC2600 Hydro Series Brush Cutter Owner’s Manual
4. Units equipped with electric starters: Turn the switch right until engine starts, only cranking over the engine for 10 sec at
a time if it does not immediately start.
Start/Stop switch
DO NOT START equipment with drive or blade clutch engaged.
5. Units equipped with manual starters: Pull starter rope to start engine.
PULL STARTER CORD slowly until resistance is felt. Then pull cord rapidly to avoid kickback.
6. Push choke in (Honda engine only).
7. Pull throttle control back to and allow engine to reach correct operating speed.
CUTTING
The best performance is achieved when cutting in dry conditions. The quality of the cut is directly related to ground speed
during cutting. Under most conditions cutting should be done at a slower ground speed. Fast speeds should be reserved for
conditions where weeds and brush are thinned out or not very tall. If the quality of the cut is not satisfactory, attempt at
slower speeds.
1. Press blade clutch handle down to engage blade. Allow blade to spin up to normal operating speed.
Blade Clutch Lever