STAINLESS STEEL TABLETOP GAS GRILL MODEL NO.
This instruction manual contains important information necessary for the proper assembly and safe use of the grill. Please read and follow all warnings and instructions before assembling and using the grill. Please verify that all parts are included with your grill before beginning assembly by checking the parts and hardware list on page 8. If all parts are not included, do not attempt to assemble the grill and call customer service at (888) 922-2336 Keep this owner’s manual for future reference.
z Never operate this grill unattended. Keep children and pets away from grill at all times. z Grill is for outdoor use only. Grill should be operated on a flat, level non-combustible surface. This grill is not intended to be installed in or on recreational vehicles or boats. z Carefully follow instructions in this manual for proper assembly and leak testing. Do not use grill until leak test has been completed.
Safety Precautions z Use only 1lb (16.4oz) propane cylinders. z The LP gas cylinder used with the grill must be constructed and marked in accordance with the specifications for LP gas cylinder of the U.S. Department of Transportation (DOT) CFR 49, or the National Standard of Canada, CAN/CSA-B339, cylinders, Spheres and Tubes for the Transportation of Dangerous Goods. z Do not attempt to refill any disposable propane cylinders.
seated over the orifice located on the gas valves. Cleaning of the venturi tube should be conducted periodically. BEFORE USING PROPANE CYLINDER 1. Check cylinder and appliance seals. Never use with damaged or missing seals. Discard cylinder if dust or rust particular are in valve area. 2. Turn control valve OFF before attaching cylinder. Attach only outdoors, in a well ventilated area, away from flames, sparks or other sources of ignition.
HOW TO PERFORM LEAK TEST: Use a clean paint brush and a 50/50 solution of mild soap and water. DO NOT USE HOUSEHOLD CLEANING AGENTS. 1. Be sure control valve on regulator is in OFF position. 2. Brush soapy solution onto connection between cylinder and regulator. If growing bubbles appear, there is a leak. Retighten connection and repeat steps 1 and 2. If you cannot stop a leak, remove cylinder from regulator and check for damaged threads, dirt and debris on regulator and cylinder.
z Insert match or lighter through access hole next to the burner tube. Keep flame next to burner while pushing and turning the control knob to the “HI” position on regulator. z If the burner does not light in 4 seconds, turn knob to “OFF” and wait 5 minutes before re-lighting, to allow any accumulated gas to dissipate. If the burner will not light after several attempts, then it can be match lit.
Troubleshooting ___________________________________________________________________ Problem Problem Cause/Solution ___________________________________________________________________ Burners will not light -Out of propane -Regulator not fully tightened to cylinder. -Inspect burner for obstructions. Flame burns out on “LOW” -Has grill been sufficiently preheated before turning to “LOW”? -Too windy.
-8-
-9-
MAINTENANCE AND CLEANING: CAUTION: Always allow the grill to cool before cleaning or handling. Avoid exposing burner surface to water. Proper maintenance and cleaning will extend the life of your grill. Regulator cleaning will reduce accumulations of debris, grease and fats. Cleaning: Drip Pan: Remove drip pan from the grill and clean with mild soap and water. If pan is lined with foil, remove and replace foil, reinstall pan.