Company Gas Grill - Tabletop Gas Grill User Manual

z Insert match or lighter through access hole next to the burner tube. Keep flame
next to burner while pushing and turning the control knob to the “HI” position on
regulator.
z If the burner does not light in 4 seconds, turn knob to “OFF” and wait 5 minutes
before re-lighting, to allow any accumulated gas to dissipate. If the burner will not
light after several attempts, then it can be match lit.
z Keep your face as far away from the grill as possible and pass a lit, long stem
match through the grilling grid to the burner.
z Position the match near the burner ports. Push and turn the control knob to “HI”.
If the burner does not light in 4 seconds turn the knob to “OFF”, wait 5 minutes
and re-lighting.
OPERATE GRILL BETWEEN “HI” AND “LO” SETTING ONLY. OPERATING GRILL
BELOW THE “LO” SETTING CAN RESULT IN A DANGEROUS FLAME-OUT AND
BUILD-UP OF GAS. IF FLAME-OUT OCCURS, TURN KNOB TO “OFF” FOR FIVE
MINUTES BEFORE RE-LIGHTING.
TO TURN OFF
z After cooking, turn the grill off by rotating the control knob to OFF. Control knob
should pop up in the OFF position. If control knob does not pop up, disconnect
cylinder to turn the grill off and replace the regulator.
z Allow grill to cool completely before handling.
TO STORE
Make sure the grill has completely cooled. Remove propane cylinder and replace
plastic cap on cylinder. Remove regulator from the grill to help keep dirt out of the
propane cylinder probe. To protect the regulator during storage and transport, the
regulator has been designed to be easily installed or removed from the grill. Before
use, screw the regulator assembly into the plate on the side of the grill. Tighten by
hand only – no tool required. When finished grilling, allow the grill to cool, then
disconnect propane cylinder from the regulator, and unscrew regulator assembly from
grill. Store regulator in a heavy plastic bag and place inside grill.
- 6 -