Napa Valley Fire Pit Table 48”x48” Model Installation Instructions 1|Page
Contents Contents……………………………………………………..2 Required Tools…………………………………………..3 Placing and Assembling the Table…………………….………………………………………4 Gas Connection………………………….…………….6 Igniter Installation…………….………………………...7 90245:A 9.25.
Required Tools Utility Knife To cut and remove packaging 2 Open Ended Wrenches To make gas connections Leather Gloves To protect hands from rough edges found on the coffee table. One (1) AAA Battery (not included) Required for piezoelectric igniter installation.
Placing and Assembling the Fire Pit table 1. Remove all components from packaging and inspect for damage or missing parts. 2. Move the base to desired location and set into place. When locating your coffee table, refer to the Crystal Fire manual and maintain clearance to combustibles. 3. Place a mounting bracket flush with the underside of tabletop in the position shown. Secure with 4 selfdrilling screws. Insert Screws Repeat this step for opposite end of table.
4. Set top assembly on base, centering the newlyinstalled brackets over the framing as shown. Insert 4 self-drilling screws and repeat for opposite side. 5. With top securely fastened to base, set tiles into place.
Read and understand your Crystal Fire owner’s manual before beginning burner hookups or using the device. Gas Connection 1. With proper orifice installed for the application and metal flex hose attached (see burner owner’s manual) set burner in base with burner neck pointed toward the control panel. 2. Connect the incoming gas hose to the valve and tighten securely. Repeat with flexible metal gas line from the valve to the underside of burner.
Igniter Installation 1. Make sure the valve is in the OFF position 2. Unscrew sparker cap and hex nut (sparker included with burner). Install as shown below.
3. To properly install ignition system, a spark and ground wire need to be attached to the igniter box. Your burner will arrive with three wires coming from the underside of the burner assembly. The ORANGE wire is used only for remote operated burner systems. The remaining two wires can be plugged into the ports on the back side of the sparker box in your control panel. Burner 4. Test system by depressing the button on the igniter.
Locating your Tank 1. Your tank should be positioned so that the fuel can be shut off after each use. 2. Slide the tank into the framework past the line shown below (table style may vary). This is to allow the door to close completely. 3. Confirm all hoses are clear and not touching the burner.
Door Installation *Exact model may differ Door support Set door on supports and close. Magnet will hold door in closed position. Finishing touches Once fire pit is set up and in the desired position, scatter decorative glass on burner surface forming an even layer of beads.
IMPORTANT Please consult your Crystal Fire instruction manual for detailed instructions and important information related to hooking up your linear burner, including safety information, proper tightening of connections with two wrenches and full burner setup and lighting instructions. DO NOT ATTEMPT TO INSTALL BURNER WITHOUT FIRST CONSULTING THE USER MANUAL.
© 2012 The Outdoor GreatRoom Company 2015 Silver Bell Road • Suite 195 • Eagan, MN 55122 Toll Free: 1-866-303-4028 • Sales@OutdoorRooms.