The Pointe Fire Pit Assembly and Operating Instructions for The Pointe Fire Pit 1|Page
Contents Contents……………………………………………………..2 Required Tools…………………………………………..3 Placing and assembling the Table.……4 Igniter Installation…………….………………………...6 Locating Propane tank……………………………8 Finishing Touches……………………………………….
Required Tools 2 Open Ended Wrenches To make gas connections Leather Gloves To protect hands from rough edges found on the coffee table. One (1) AAA Battery (not included) Required for piezoelectric igniter installation.
Placing and Assembling the Fire Pit table 1. After removing the fire pit from packaging, move the base without door to desired location and set into place. 2. When locating your coffee table, refer to the Crystal Fire manual and maintain clearance to combustibles. 3. Set the SuperCast into place on the fire pit base. Make sure the top is centered over the opening before proceeding. 4.
*base shown may differ from actual product Attach incoming gas here Stainless flex line to burner 6. Connect incoming gas line (black rubber propane hose or hard pipe from outside source) to the lower fitting on the control valve , ensuring the knob is in the “OFF” position. Carefully set burner back into place in the table top. Check system for leaks before use Read and understand your Crystal Fire owner’s manual before beginning burner hookups or using the device.
Igniter Installation 1. Make sure the valve is in the OFF position 2. Unscrew sparker cap and hex nut. Install as shown below.
3. To properly install ignition system, a spark and ground wire need to be attached to the igniter box. Start by plugging the black wire hanging from the burner in to one side of the back of the igniter. Plug the included grounding wire (which arrives attached to the underside of the burner) into the back of the sparker box NOTE: Orange wire hanging from burner is not used for this installation. Test system by pushing the button on the igniter.
Locating your Tank 1. Your tank should be positioned so that the fuel can be shut off after each use. 2. Slide the tank into the framework past the line shown below. This is to allow the door to close completely. 3. Confirm all hoses are clear and not touching the burner. Position tank behind this line Install door by setting the bottom on the catching hooks first and then closing. Magnets in the table will hold door closed.
Finishing touches Once fire pit is set up and in the desired position, scatter decorative glass on burner surface forming an even layer of beads. DO NOT BURN WITHOUT GLASS OR OTHER DECORATIVE SUBSTRATE PRESENT IMPORTANT Please consult your Crystal Fire instruction manual for detailed instructions and important information related to hooking up your linear burner, including safety information, proper tightening of connections with two wrenches and full burner setup and lighting instructions.
Warranty: Fire pit tables are covered under a 1year manufacturer’s warranty. Please visit http://www.outdoorrooms.com/warranty-form to register your product. © 2014 The Outdoor GreatRoom Company 2015 Silver Bell Road • Suite 195 • Eagan, MN 55122 Toll Free: 1-866-303-4028 • Sales@OutdoorRooms.