Manual

7 | P a g e
3. To properly install ignition system, a spark and ground wire
need to be attached to the igniter box.
 Start by plugging the black wire hanging from the
burner in to one side of the back of the igniter.
 Plug the included grounding wire (which arrives
attached to the underside of the burner) into the back
of the sparker box
 Test system by pushing the button on the igniter. A
continuous repeating spark between the igniter
electrode and spark-receiving probe means everything
is connected properly. Consult the troubleshooting
section if spark is weak, intermittent, or not present.
4. Once ignition system is grounded and gas
connections are secured and checked for
leaks, set the burner back into its original
position .
NOTE: Orange wire hanging from burner
is not used for this installation.