Sonoma 16 and 1216 Pergola Manual and Installation Instructions Please read these instructions before removing parts from crate
Introduction Thank you for your purchase from The Outdoor GreatRoom Company. This pergola has been engineered and manufactured in the USA. This user manual will help make the installation and setup of your new pergola fast and easy. Outdoor GreatRoom company recommends visiting with your local authority for building codes, restrictions, or requirements for this product. Please read the manual through before starting the project. This pergola is made of premium grade kiln dried Douglas Fir.
Included Parts: B A Col- Arch Mending plate C Tall Corbel Post Brace Foot x10 Short Corbel Post Brace x4 L M ALL bolts require washers M10x 55 Hex Bolt X4 X4 G x30 X4 Canopy Beam, Right L Canopy Beam, Left L N M10 x160 Hex Bolt (with nut and wash- I H (with nut and washers) ers) Canopy Beam, T x8 O M10 x 90 Hex Bolt (with nut and washer) 1.
D Step 2: Step 1: Bolt steel footplate to each of four supplied posts “A” as shown. Use hardware “M”, and “O”. F H Step 3: D K G E X Q Apply construction adhesive to boards on one side and bolt beams X together as shown using bolts “P” with a nut and washers. Bolt heads should be on the side comprised of beams “E” (Do not use bolts in holes marked with an X above.) Repeat for opposite side ledger beam.
NOTE: In the remaining steps, a rubber mallet may be useful in fitting beams together properly. Step 5: Step 7: Once header beams are installed and bolts are tightened, end arched beam sections can be installed between them and secured in place with hardware screws “R”. Position components with bolt E Lay columns on level surface. Bolt ledger beams assembled in step 2 to columns “A” with beams “E” facing upward.. E Hardware “O” is used. Repeat step 5 for remaining posts.
Step 8: Carefully position posts in final location. Check for square. Install canopy beam assemblies with screw “R” at intersections with arch beams. The use of a level or similar tool is highly suggested.
Dimensional and Post Location Information NOTE 1: Dimension Recommended 12-18” DIA footing (12” minimum). Check local codes for depth minimums. Footing typically 24” minimum depth, 42” for extreme cold climates. NOTE 2: Do not complete final tightening of all bolts until the pergola is full assembled, level, and square. After the pergola is IN POSITION, SQUARED, AND LEVELED, anchor posts with masronry bolts through the steel foot plates.
Sonoma Pergola Warranty Information Your new Sonoma pergola is warranted against structural defects for a period of three (3) years from the date of purchase. This does not apply to damage caused by excessive loads such as snow or use of roof as storage. Your Sonoma pergola is warranted against defects in finish and other defects not related to structure for a period of one (1) year from the date of purchase.
