Quick Start Guide

• THIS GUIDE IS ONLY TO BE USED AFTER YOU READ AND UNDERSTAND THE FULL INSTALLATION INSTRUCTIONS
SUPPLIED WITH YOUR CRYSTAL FIRE® PLUS BURNER.
• THIS GUIDE ONLY APPLIES TO 20LB. SELF-CONTAINED PROPANE INSTALLATIONS. ALL OTHER INSTALLATIONS ARE FOUND
IN FULL INSTALLATION INSTRUCTIONS.
+
-
FLEX-LINE AND BURNER
ORIFICE CONNECTION
FLEX-LINE AND VALVE
CONNECTION
REGULATOR HOSE AND
VALVE CONNECTION
FLEX-LINE AND BURNER
ORIFICE CONNECTION
FLEX-LINE AND VALVE
CONNECTION
REGULATOR HOSE AND
VALVE CONNECTION
EITHER WIRE CAN CONNECT
TO EITHER CONNECTION POINT
SEE DETAIL B
SEE DETAIL A
SCALE 0.800
DETAIL A
SCALE 0.800
DETAIL B
SPREAD MEDIA EVENLY
ACROSS BURNER SURFACE
MEDIA CAN BE PLACED ON
IGNITION WIND GUARD COVER
NO MEDIA INSIDE
IGNITION WIND GUARD
OPENING
SPREAD MEDIA EVENLY
ACROSS BURNER SURFACE
MEDIA CAN BE PLACED ON
IGNITION WIND GUARD COVER
NO MEDIA INSIDE
IGNITION WIND GUARD
OPENING
BURNER FLEX-LINE
AND ORIFICE CONNECTION
(OUTLET SIDE)
PROPANE TANK AND
REGULATOR HOSE
CONNECTION
(INLET SIDE)
REGULATOR HOSE
AND VALVE CONNECTION
(INLET SIDE)
BURNER FLEX-LINE
AND VALVE CONNECTION
(OUTLET SIDE)
OFF
LOW/
IGNITION
HIGH
PRESS AND HOLD
SPARKER BUTTON
ROTATE COUNTER-CLOCKWISE
TO LOW AND SLOWLY DEPRESS
HOLD KNOB IN FOR 3-5 SECONDS
Secure the control panel in place.
Crystal Fire® Plus Burner
Quick-Start Guide
Secure the sparker box to the control panel.
Using two adjustable wrenches, ensure all plumbing
connections are tight.
Secure the control valve to the control panel
with the two screws provided.
Connect igniter and ground wire to sparker box. Carefully uncoil the thermocouple lead. Connect to
the valve rst by hand then tighten with a 10mm
wrench. One thread should be visible when properly
installed. DO NOT cross-thread thermocouple
connection.
Connect hose and regulator to self-contained
propane cylinder.
Place media in burner DO NOT GET ANY MEDIA
INSIDE THE IGNITION WIND GUARD.
If no leaks are present, your system is ready to use.
Test re unit and check for leaks prior to full operation.
Remove the cardboard from ignition wind guard.
Carefully place burner into enclosure location.
2
2
3
3
4
4
5
5 66
7
7
8
8
9
9
10
10
1
1
www.outdoorrooms.com
42517 REV A: 04-20-2020