The Cove Fire Pit Installation Instructions for CV-1242
IMPORTANT Please consult your Crystal Fire instruction manual for detailed instructions and important information related to the burner installation including: lighting and operating instructions, safety information, and proper tightening of connections with two wrenches. DO NOT ATTEMPT TO INSTALL CF-1242 BURNER WITHOUT FIRST CONSULTING THE CRYSTAL FIRE OWNER’S MANUAL. Contents Required Tools………………………………….........2 Included with your Fire Pit………………………..3 Assembly Instructions……………………………….
Included With Your Fire Pit CV-1242-BASE with Control Panel CF-1242 Crystal Fire Burner Kit 3
Assembly Instructions 1. Remove Cove-1242-Base from Packaging crate Four People are required to lift base out of packaging and place into final location. 2. Sparker Box Installation Remove sparker cap and hex nut. Insert AAA battery (not included) with + end out. Install sparker into control panel as shown below, secure using hex nut and replace sparker cap. Depress sparker button to ensure your sparker is working properly. You should hear the spark behind the sparker box.
3. Gas Connections Reach inside the base and attach gas supply line to the input shown below, using a 3/8” flare fitting. Use two wrenches to ensure a gas tight connection. TIGHTEN CONNECTION SECURELY WITH WRENCH Gas Supply Ensure the correct orifices are installed for the fuel type you are using (see Crystal Fire Burner Owner’s manual included with burner for orifice sizing information).
4. Connect Ground wire and Electrode wire from burner to sparker box. Plug both BLACK wires hanging from the burner into the back of the sparker box. If an orange wire is present, do not use it. The orange wire is for automatic ignition system add-on only. Test system by pushing the button on the igniter. Consult the troubleshooting section of the Crystal Fire Burner Owner’s Manual, if the spark is weak, intermittent, or not present. 5. Drop Burner into base.
6. Install Fire Media Scatter all included glass beads, lava rock, or other approved fire media evenly across entire burner surface. DO NOT OPERATE CRYSTAL FIRE BURNER WITHOUT INCLUDED GLASS BEADS OR OTHER APPROVED FIRE MEDIA IMPORTANT Please consult your Crystal Fire instruction manual for detailed instructions and important information related to the burner installation including: lighting and operating instructions, safety information, and proper tightening of connections with two wrenches.
Warranty: Fire pit tables are covered under a 1year manufacturer’s warranty. Please visit http://www.outdoorrooms.com/warranty-form/ to register your product. Thank you for purchasing an Outdoor GreatRoom Company product! This fire pit was made with pride in the USA. 14400 Southcross Drive West • Suite 100 • Burnsville, MN 55306 Toll Free: 1-866-303-4028 • Sales@OutdoorRooms.
