The Cove Fire Pit Installation Instructions for CV-30 1
IMPORTANT Contents Please consult your Crystal Fire Burner Owner’s instruction manual for detailed instructions and important information related to Required Tools…………………………….…..2 hooking up your burner, including safety information, proper tightening of connections with two wrenches, and full burner setup Included with your Fire Pit……………….3 and lighting instructions. DO NOT ATTEMPTInstructions………………….………4 TO INSTALL CF-30 BURNER WITHOUT FIRST Assembly CONSULTING THE CRYSTAL FIRE BURNER OWNER’S MANUAL.
Included with your Fire Pit CV-BASE with Key Valve Control Panel Key for Key Valve Crystal Fire CF-30 Burner Kit 4
Assembly Instructions Included with your Fire Pit A. 4 Fasteners 1. First, unscrew the shipping block with a power drill. Discard B. 4 B-Bolts board. It will not be needed for further assembly of this C. 4 C-Bolts product. 2. D. Remove fireCaps pit base from the crate you received it in. Place 4 Bolt the base in your desired location. Three people are E. Touch-Up Paint Bottle recommended for this step of the installation. Shipping Block Assembly Instructions . 1 .
Igniter Installation 1. Make sure the valve is in the OFF position before beginning. 2. Remove sparker cap by turning counter-clockwise and insert a AAA battery (not included). Gas Connections Read and understand your Crystal Fire Burner Owner’s manual before beginning burner hookups or using the device. Do not use Teflon tape or pipe dope on flare fittings. 1. Reach inside the base and attach gas supply line to the input shown below, using a 3/8” flare fitting.
2. Ensure the correct orifices are installed for the fuel type you are using (see Crystal Fire Burner Owner’s manual included with burner for orifice sizing information). TIGHTEN SECURELY WITH TWO WRENCHES 1. Reach inside the base and attach gas supply line to the input shown below, using a 3/8” flare fitting. 3. Attach flex line from the burner to gas valve as shown below.
Sparker will not operate correctly without an ignition and ground wire attached. Igniter Installation (continued) Sparker will not operate correctly without an ignition and ground wire attached. Plug both BLACK wires hanging from the burner into the back of the sparker box. If an orange wire is present, do not use it. The orange wire is for automatic ignition system add-on only. Test system by pushing the button on the igniter.
Glass Installation Glass Installation 1. Scatter all the included glass beads evenly onto burner surface.
IMPORTANT Please consult your Crystal Fire Burner Owner’s instruction manual for detailed instructions and important information related to hooking up your burner, including safety information, proper tightening of connections with two wrenches, and full burner setup and lighting instructions. DO NOT ATTEMPT TO INSTALL CF-30 BURNER WITHOUT FIRST CONSULTING THE CRYSTAL FIRE BURNER OWNER’S MANUAL.
Warranty: Fire pit tables are covered under a 1year manufacturer’s warranty. Please visit http://www.outdoorrooms.com/warranty-form/ to register your product. Thank you for purchasing an Outdoor GreatRoom Company product! This fire pit was made with pride in the USA. 14400 Southcross Drive West • Suite 100 • Burnsville, MN 55306 Toll Free: 1-866-303-4028 • Sales@OutdoorRooms.