Installation Guide

ManualsBrandsOutdoor Living Today ManualsPergolas10 ft. x 10 ft. Breeze Cedar Pergola with Retractable Canopy

Assembly Manual

OLM Retractable Canopy for

10X10 Breeze Pergola

Outdoor Living Today

Toll Free 1-888-658-1658 www.outdoorlivingtoday.com sales@outdoorlivingtoday.com

Page 1

Revision #5

October 4, 2017

Customers agree to hold Outdoor Living Today and any Authorized Dealers free of any liability

for improper installation, maintenance and repair of any Outdoor Living Today products.

In the event of a missing or broken piece, simply call the Outdoor Living Today Customer Support

Line @ 1-888-658-1658 within 30 days of the delivery of your purchase. It is our commitment to

you to courier replacement parts, free of charge, within 10 business days of this notification.

Replacement parts will not be provided free of charge after the 30 day grace period.

Care and Maintenance -

Canopy should be removed in winter to reduce the chance of collapse during heavy snow falls.

Never leave canopy extended during snow, heavy rains or serious wind strorms.

Reasonable care should be taken to remove accumulated dirt and debris in track.

Lubrication (supplied in kit) of wing wheels and track should be done annually.

Check Wheels, Axels, and all fasterners annually for wear and defect. Replace as required.

Do not over-tighten fasteners attaching Track. Over torquing can break screw head off.

Canopy Tracks may have sharp corners. Always use gloves when handling to prevent cuts.

To keep the Harbor-Time canopy fabric looking clean and bright, wash periodically with a soft brush,

warm water and mild soap. Do not use detergent.

5 year limited manufacturer's warranty on the Harbor-Time canopy fabric.

Summary of content (11 pages)

PAGE 1
Assembly Manual OLM Retractable Canopy for 10X10 Breeze Pergola by Outdoor Living Today Revision #5 October 4, 2017 Care and Maintenance Canopy should be removed in winter to reduce the chance of collapse during heavy snow falls. Never leave canopy extended during snow, heavy rains or serious wind strorms. Reasonable care should be taken to remove accumulated dirt and debris in track. Lubrication (supplied in kit) of wing wheels and track should be done annually.
PAGE 2
Once your pergola and retractable canopy have been correctly installed, do a water test to confirm water is draining properly from the canopy. Please contact us immediately if large amounts of water remain in each fabric fold when extended. The Canopy is designed to hold several gallons of water per fold. If more than a gallon of water is collecting in each fold, keep the canopy closed until a solution is found. Failure to do so could void your warranty.
PAGE 3
10x10 Breeze Pergola Retractable Canopy Parts List Parts List 1 1/4” Self Tapping Pan Head Screws -14 Pcs. 1 1/4” Brown Wood Screws - 8 Pcs. 3” Brown Screws - 8 Pcs. A - 1 1/2” x 1 1/2” x 8 1/2” Canopy Lowering Cleat - 3 Pcs. B - 115 1/2” long Canopy Tracks - 2 Pcs. C - 109” long Aluminum Wings (5) with 4 Canopy Fabrics. (EWF) (Plastic Wheel attached to each Wing end). Actual Aluminum Wing Length - 106 1/4” Actual Fabric Length - 106 1/2” 4 1/4” D - Aluminum Wing Stop 4 1/4” Long- 2 Pcs.
PAGE 4
Installation of the OLM Retractable Canopy couldn’t be easier. Just 4 Easy Steps! 1. Attach lowering cleat and canopy tracks to pergola framing. 2. Lift aluminum wings with canopy and feed wheels into track. 3. Position aluminum wing stop and attach. 4. Install knobs to anchor both ends of your canopy. Installation will require 2 people. 1. 2. 4. 3. Toll Free 1-888-658-1658 www.outdoorlivingtoday.com Page 4 sales@outdoorlivingtoday.
PAGE 5
3 Cleats 1. With a Step Ladder, install Part A - Canopy Lowering Cleats - 3 pcs. (1 1/2” x 1 1/2” x 8 1/2”) with 2 - 2 1/2” screws. Cleats will lower the canopy on one side and drain water off the fabric so it doesn’t collect excessively. Decide best side for water to drain for your situation. Position cleats underneath pergola joists or blocking as shown above and attach. Cleats are pre-drilled 3/4” from each end.
PAGE 6
Gap 3. Align and attach second Canopy Track directly underneath lowering cleats as per Step 2. Position track with drilled end flush against post as illustrated above. Track Track Lubricant Part C (5 Wings) Toll Free 1-888-658-1658 4. Prior to feeding Part C - Aluminum Wings and Canopy into track, locate Lubricant in Hardware Pack and apply a small amount to top of each wheel. Spin wheel slowly to lubricate entire surface. Complete all wheels. www.outdoorlivingtoday.
PAGE 7
Rope Knot on inside Lead Wing 2 Anchor Rope on last wing facing out Pull Rope on Lead Wing Gap side ing W nd 5. Before feeding Part C - 109” long Aluminum Wings (5) with Canopy into track, make sure canopy fabric is facing the correct direction. First, locate Lead and Anchor Wings in set. Both have a black pull rope attached. Make sure rope knots are facing to the inside and the pull rope is facing to the outside. Starting with the Lead Wing, feed the wing wheels onto the track as shown above.
PAGE 8
7. Continue to feed wings Win ing W ad Le 2nd into the track until all wings are installed. g 3rd Wing 5 Wings Anchor Wing Both sides 8. Install Part D - 4 1/4” long Aluminum Wing Stops - 2 Pcs. where track ends and gap exists. Use 2 - 1 1/4” brown screws per stop to install. When removing the wings and canopy in the future, simply remove wing stops and roll wing and canopy out carefully with a helper. Toll Free 1-888-658-1658 www.outdoorlivingtoday.com Page 8 sales@outdoorlivingtoday.
PAGE 9
Part F - Canopy Pull Handle 9. Using Part F - Canopy Pull Handle, pull canopy back and forth a few times to lubricate wheels and track. If wing binds, stop and pull foward until wings are straight and start again. When wings and canopy are tracking well, pull canopy to anchor side of pergola to install Part E - Wing Anchor Knob. Lead Rope Canopy Locking Clip. Anchor Rope Ou tsid eG ird er Part E - Wing Anchor Knob 10.
PAGE 10
Lead wing tight against corner bracket Lead Rope 11. Pull canopy out using pull handle on lead rope. Fully extend canopy until outside lead wing contacts corner bracket or until canopy cannot extend further. Follow Step 10 to position and attach wing anchor knob to outside girder. 12. Extend and contract the canopy several times with pull handle. When extending or contracting the canopy, pull firmly in one continuous motion to prevent wings from binding.
PAGE 11
Congratulations on installing your OLM Retractable Canopy from Outdoor Living Today. Care and Maintenance Canopy should be removed in winter to reduce the chance of collapse during heavy snow falls. Never leave canopy extended during snow, heavy rains or serious wind strorms. Reasonable care should be taken to remove accumulated dirt and debris in track. Lubrication (supplied in kit) of wing wheels and track should be done annually. Check Wheels, Axels, and all fasterners annually for wear and defect.