Installation Guide

2. With Step Ladders and assistance, lift up Part B - 115 1/2” long Canopy Track and position
against post and tight to the underside of pergola joist on side (use side without lowering cleats first).
Align track with drilled end (2 3/4” away from one end) against post. Attach track to post with
1 - 1/4” Brown Screw. On opposite end of track, screw 1 - 1 1/4” Sliver Self Tapping Screw up
through the track into bottom of wood joist. Attach a second 1 1/4” Silver Self Tapping Screw in the
center of the track into the bottom of joist.
Gap for wooden wing
stop is generally the
anchor end of canopy
and where the fabric
will bunch up.
Gap
Flush
1. With a Step Ladder, install Part A - Canopy Lowering Cleats - 3 pcs. (1 1/2” x 1 1/2” x 8 1/2”)
with 2 - 2 1/2” screws. Cleats will lower the canopy on one side and drain water off the fabric so it
doesn’t collect excessively. Decide best side for water to drain for your situation. Position cleats
underneath pergola joists or blocking as shown above and attach. Cleats are pre-drilled 3/4” from
each end.
3 Cleats
Part B
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 5