Installation Guide

6. Carefully lower (C) Girder down into notch of (B)
Girders. Be careful not to twist the Girder when
dropping down into place. Lag Screw Girder to
Post. Pilot hole first.
Use 2 Washers and
Lag Screws.
7. Lift, position and Lag Screw the second (C)
Girder to Posts.
8. On level ground, position 1 Joist (D)
and 8 Stub Joists (E).
Joists are pre-marked on top edge for
Stub Joist and Blocking positioning.
(C) Girder
(C) Girder
Pre-marked for Stub
Joist placement
D
E
Notches facing down
C Girder
Note: Pilot hole Post
first with 1/4” drill bit.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 6