Instructions / Assembly

33. Place Leg Support Bracket (R) in corner and attach to Bar and Leg framing with
2 - 2 1/2”screws through pre-drilled holes in brackets. Complete 2 brackets per leg.
34. Complete remaining Leg Panels (center and end) following alignment and attachment
procedures in Step 33.
35. Set completed Bar /Seat Bench between Posts so flush on inside of Post. Place Bar/Post
Support Bracket (S) against Bar framing and Post. Drill 1/4" pilot hole into bar frame and post,
and lag bolt (3"x3/8" with washers) thru bracket into frame and into post. Complete both sides.
Leg
Support
Bracket
Leg Support
Brackets have 1/8”
Pilot Holes drilled.
Center Leg
Panel
End Panel
Bar Support Bracket
has 3/8” Pilot Holes.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 15