Warranty

66. Attach Facia/Trim Detail Plates to cover seam where facia and horizontal trim pieces come
together. Secure each with 4 - 1 1/4” finishing nails.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 26
67. Place First Roof Ridge Cap (Lower Grade Undercourse Ridge Cap) on roof peak overhanging
shingles by approximately 1”. Attach with 2 - 1 1/4” Shingle Nails 9” from end. Place 2nd Ridge Cap
1” back from 1st cap. Attach with 2- 1 1/4” Shingle Nails 9” from end. Alternate each Ridge Cap seam
as you proceed.
68. Place 3rd Ridge Cap 8” back from 2nd. (enough to cover shingle
nails). Attach 3rd Ridge Cap down as per Step 67. Continue to position
and attach Ridge Caps until half roof is complete. From opposite side,
position and attach Ridge Caps as described above. Score/cut 1 Ridge
Cap to 12” or to fit in the center of roof. Attach center cap with 4 - 1 1/4”
Shingle Nails.
9” from end
Alternate Ridge Cap Seams
(Offsetting angle cut at peak)
8”
8”
Undercourse
Ridge Cap
Important: Butt (thick) end
of Ridge Cap will be facing
towards the outside of shed.
thick end
thin end