Warranty

15. Starting at Rear Corner, position a Solid Wall Panel
on top of plywood floor. The Wall Panel bottom framing will
sit flush with plywood. Wall siding will overhang the floor.
Important: Make sure all walls are
aligned in their upright position. If not
,water may leak into your shed. Unsure
if panel is facing up or down? Check
siding on window wall panel to match
alignment.
16. The rear wall panels will sit flush at
the end of the plywood floor with the
sidewall panels sandwiched between them.
Note: Siding will overhang the floor by
approximately 1/2”.
Outside 2x3 framing of wall panel
is flush with outside of plywood
when properly aligned.
Wall Panel
Side of Shed
Bottom Wall Plate
14. Starting with Solid Wall Panels, carefully lay panel face down. Position and attach Wall Plate
to bottom of wall studs of each wall panel with 3 - 2 1/2” screws. Position so plates are flush with
framing.
Side of Shed
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 8