Instructions / Assembly

32. Lift up a completed gable section and place on top of Rear Top Plate on wall. The rear gable
framing should sit flush with the inside of the top plate.
33. The gable should be centered sideways (left to right) on the top plate. Hint: use a straight edge
to check the angle of the gable framing and top plate. Both angles should line up. Adjust gable
accordingly. Temporarily attach Gable to walls and top plate with 2 - 2” screws. Screw from the
bottom of gable framing down into Top Plate and Wall. Gables may need slight adjustment in Step 44
and then will be completely attached with an additional 6 - 2” screws.
34. Complete positioning and attachment of front gable as per Step 32-33.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 14
straight edge
Flashing overhangs
wall siding.