Instructions / Assembly

bottom skirting
69. Attach Door Hinges to Door Panel. At this stage,
door can swing open on the left or right. Decide on your
preference and attach hinges to door. (3 hinges per door
centered on door trim.) Use 3/4” and 2” long black screws
on hinge / door attachment as illustrated above.
70. Place Door panel into position, gap
3/8” on bottom and evenly spaced on
sides and attach hinges to Narrow Trim
with 1 1/2” black screws. Use shim to
help keep the door evenly spaced on
bottom. See Step 71 for gap at top.
Door
3/8” gap at
bottom.
Evenly
spaced on
sides.
3/4” screws
Narrow Trim
2” Black Screws
Door Trim
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 26
67. Place First Roof Ridge Cap on roof peak overhanging shingles by approximately 2”. Attach with
2- 1 1/4” Shingle Nails 9” from end. Place 2nd Ridge Cap 1” back from 1st cap. Attach with
2- 1 1/4” Shingle Nails 9” from end.
68. Place 3rd Ridge Cap 8” back from 2nd (enough to cover shingle nails).
Attach 3rd Ridge Cap down as per Step 67. Continue to position and attach
Ridge Caps until half roof is complete. From opposite side, position and
attach Ridge Caps as described above. Score/cut 1 Ridge Cap to 12” or to
fit in the center of roof. Attach center cap with 4 - 1 1/4” Shingle Nails.
9” from end
8”
8”
2“ Screws
Important: Butt (thick)
end of Ridge Cap will
be facing towards the
outside of shed.