Use and Care Manual

46.
Roof Gussets are positioned on both mid rafters. Slide gusset up, use level to square gusset
and attach to rafters with 4 - 2” screws. Pilot hole each Gusset end with 1/8” drill bit. Complete
remaining Gusset.
45. Secure Rafters to Top Wall Framing with one 3” screw per rafter. Screw through Wall Frame at
an angle. Have two helpers push the side walls at the top from the outside of shed until inside to inside
measurement between the side plates is 91”.
47. Identify Roof Panels. There are 2 Rear and 2 Front Roof Panels. Starting with a Right Rear
Roof Panel, lift up and place on rafters.
Shingles overhang
plywood on outside
panels.
Shingles and
plywood flush
at center.
Right Rear
Roof Panel.
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 19
91” across