Use and Care Manual

1 - 2” screws per
Hinge initially.
17. Leave a gap on left side and bottom of
Door approximately 1/8”. Use a shingle to
shim the door at bottom to help position
door evenly.
When door is aligned correctly, screw Hinge
into Vertical Door Frame Trim with 2” Black
Screws.
Use only 1 screw initially per hinge until
both door alignments are confirmed. Drill
pilot holes to prevent wood from splitting.
Shim with
Shingle
1/8”
gap
1/8” gap
Gap between
Top of Door
and Door
Header
19. Position Right Side Door as per Steps 16-17. Once again, use only 1 screw per hinge initially to
secure Door to Vertical Door Frame Trim. Open and close both Doors to confirm proper Door closing.
Re-adjust Door Screws if necessary. When satisfied, complete Hinge attachments with 2 additional 2”
Black Screws per Hinge.
1 - 2” Black
Screw initially
Complete with 2 additional 2”
Black Screws per Hinge when
Doors are positioned correctly.
Gap
between
Doors will
be covered
by Door
Flange (K)
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 10