Use and Care Manual

Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [e-mail]
Page 13
Flush with
Bottom Skirting
Center
Rear Trim
(S)
26. Place Center Rear Trim (S) over
Rear Wall Seam. Trim should sit flush
at bottom with Skirting. When correctly
aligned, secure with 8 - 1 1/4” nails.
27. Locate Front Door Header Trim (T) and place between Corner Door Trim flush against Door
Header and Plywood Roof. Make sure Door Header Trim is positioned so it does not impede the
opening and closing of Doors. When correctly positioned, secure with 5 - 1 1/4 nails.
Front Door
Header Trim (T)
28. Unfold Sheet of Roofing Paper (U). Place on Plywood Roof evenly and nail down with
4 - 7/8” nails. Position nails to penetrate through Plywood Roof into wall framing.